Table of Contents
Advertisement
Invacare® Action 3 NG
Adjusting the height
1. Loosen the screw B with 5 mm Allen key in the groove
C of the armrest tube.
2. Move the armrest upwards or downwards until you
reach the desired height, while keeping screw B in
place (at the top edge of the holder).
3. Tighten the screw B (5–6 Nm).
4. Perform the setting on both sides.
3.7.3 Armrest, height adjustable, removable
Removing
1. Previously press on the locking mechanism A located
at the bottom of the armrest vertical bracket (if so
equipped).
2. Pull the armrest by the arm cushion out of the holder.
Fitting
1. Push the armrest into the holder.
24
Adjusting the armpad height
1. Loosen the screw B with 5 mm Allen key at top of the
armrest tube.
2. Move the armrest upwards or downwards until you
reach the desired height, while keeping screw B in
place.
3. Tighten the screw B (5–6 Nm).
4. Perform the setting on both sides.
Adjusting the armpad depth
1. Loosen the 2 screws C below the armrest bracket.
2. Move the armrest frontwards or rearwards until you
reach the desired depth, while keeping screw C in
place.
3. Tighten the 2 screws C (1,5–2 Nm).
4. Perform the setting on both sides.
Adjusting the side protection height
1. Loosen the 2 screws of the side protection clamps D.
2. Move the side protection upwards or downwards until
you reach the desired height.
3. Tighten the 2 screws of the side protect clamps D
(0,7–1,2 Nm).
4. Perform the setting on both sides.
1608467-E
Advertisement
Table of Contents
