Table of Contents
Advertisement
Invacare® Action 3 NG
4 Options
4.1 Comfort version
It is made up of a rigid shell A and a preformed foam
cushion B which is locked in place by hook and loop
fasteners. The backrest shell is removable to allow the
folding of the wheelchair. The comfort version is always
delivered in passive rear wheel position for a better stability.
WARNING!
Risk of injury
– Never lift the wheelchair by the backrest shell.
CAUTION!
Risk of pinching
– Keep your fingers away from movable parts
during folding, disassembling or adjustment.
Remove the backrest shell
32
1. Slightly loosen the two hand screws C .
2. Slide the levers D inwards until they are in open
position.
3. Disengage the hooks E from their supports.
Install the backrest shell
1. Engage the hooks E into their supports.
2. Slide the levers D outwards until they are in lock
position.
3. Firmly tighten the two hand screws A and makes sure
that the TWO hand screws A are properly tighten .
It is recommended that this operation be performed
only by the attendant. It is important to ensure that
the backrest shell is correctly fitted and engaged
at all times when the chair is in use. Make sure
the backrest cushion hook and loop fasteners are in
good state and well positioned.
4.2 Transit version
The transit version is designed to be driven only by the
attendant. To facilitate sideways transfers and save space,
the wheelchair is equipped with rear wheels of 305 mm
(12").
The distance between the brake shoe and the tyre
can be adjusted. The adjustment must be carried
out by a qualified technician.
The manual brakes (optional drum brake) are only accessible
to the attendant; operate the handle (A) to lock the
wheelchair in parking position.
1608467-E
Advertisement
Table of Contents
