Sym ALA125CC Manual page 97

2. MAINTENANCE INFORMATION
Gear Oil
Inspection
Check gear oil if leaking.
Park the motorcycle with main stand on flat
level place.
Turn off engine and remove the gear oil
draining plug.
Place a measurement cup under the draining
hole.
Remove the oil drain plug and drain gear oil
into a measurement cup.
Check gear oil if enough.
Replacement
At first, remove the gear oil refilling bolt, and
then remove the draining plug.
Install the draining plug after drained oil out.
Torque value: 3.5~4.5 kgf-m
Caution
Inspect if washer is in good condition.
Replace it with new one if it was deformed
or damaged.
Fill out gear oil to specified quantity from the
engine oil filling hole.
Install the oil filling bolt.
Torque value: 1.0~1.4 kgf-m
Quantity: 100 c.c.
Recommended: King-Mate HYPOID GEAR
OIL ( #140 ).
Fuel System
Fuel Pipe
Remove luggage box, rear center cover,
body cover, and rear fender, as well as front
inner box.
Check all pipes, and replace it when they are
deterioration, damage or leaking.
Warning
Gasoline is a low ignition material so any
kind of fire is strictly prohibited as dealing
it.
Fuel filter
Remove the fuel tank.
Remove fuel pipe from the fuel filter.
Replace the fuel filter with new one.
Install the fuel filter.
Caution
The arrow on the fuel filter means the flow
direction of fuel and check it if leaking after
installation.
2-4
Gear oil refilling bolt
Fuel filter
SYM
Gear oil draining plug