Life Fitness Axiom Series Assembly Instructions Manual page 24

19. Thread cable end through the jam nut and into the rod end bearing a minimum of 12mm.
20. Install screw, washers, and locknut securing the bushings and rod end bearing to the pulley bracket assembly
using an 8mm Allen wrench and a 17mm wrench.
21. Select either the LBS or KG weight stack label. Remove backing from label and apply to weight stack.
NOTE: One weight stack label sheet, LBS or KG, is used for both weight stacks.
22. Test the tower assembly.
Item
1
2
3
Item
1
2
3
4
5
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Item
1
2
Page 22 of 34
Description
Rod End Bearing
Nut, M10 Hex Jam
Cable, 62" (1575mm)
Description
Rod End Bearing
Screw, M10 x 1.5, 80 mm
Washer, Flat 3/8"
Bushing, .969"
Nut, M10 x 1.5, Hex Nylock
Description
Weight Stack Label
Weight Stack
Qty.
1
1
1
Qty.
1
1
2
2
1
Qty.
1
1