3. Slide shaft collars and roller pads onto the roller pad bracket.
4. Install screws and plates securing roller pads to the roller pad bracket using an 8 mm Allen wrench.
5. Tighten set screws in shaft collars to 8-10 ft-lb (10.8-13.5 Nm) using a 4 mm Allen wrench.
6. Install bearing housing caps to the roller pads using a rubber mallet.
Assemble Tower
1. Install the increment weight bumper to the bottom plate of the tower frame.
Item
1
2
3
4
5
Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).
Item
1
2
Page 15 of 34
Description
Roller Pad
Shaft Collar
Plate, Roller Pad
Screw, M10 x 1.5, 30 mm
Bearing Housing Cap
Description
Increment Weight Bumper
Tower Frame
Qty.
2
2
2
2
2
Qty.
1
1