IBM Power System 9008-22L Manual page 81

Figure 46. Removing the high-profile tailstock from a new PCIe adapter
9. If the new adapter is a 4-Port 10/100/1000 Base-TX PCIe adapter, see "4" on page 65 for removing
the tailstock and then return here.
10. If the new adapter is an Ethernet or Fibre Channel adapter, see "5" on page 65 for removing the
tailstock and then return here.
11. Detach the tailstock from the new PCIe adapter and store the tailstock and its screws in the antistatic
package that the new adapter shipped in.
Replacing the tailstock in a new adapter
12. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
13. Place the adapter, component-side up, on a flat, antistatic surface.
Attention: A pin on the tailstock of the adapter resembles a removable screw. Do not remove
this pin. It is required for correct alignment and seating.
14. Using a Phillips screwdriver and the two retaining screws (B), attach the tailstock (A) from the failed
PCIe adapter onto the new PCIe adapter, as shown in Figure 47 on page 68.
Installing, removing, and replacing PCIe adapters in the 9008-22L, 9009-22A, or 9223-22H system 67