IBM Power System 9008-22L Manual page 80

To remove the SFP transceivers, complete the following steps:
a) Place the card flat on a static-protective surface.
b) Open the latch (A) by rotating it down and away from the card as shown in Figure 45 on page 66.
c) Slide the transceiver (B) out of the adapter hardware.
d) Repeat for the other transceiver.
Figure 45. Removing SFP transceivers from adapters
6. If necessary, remove the adapter from the antistatic package.
Attention: Avoid touching the components and gold connectors on the adapter.
Removing the tailstock from a new adapter
7. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
8. Using a Phillips screwdriver, unscrew the two retaining screws (A) that attach the high-profile
tailstock (B) to the new PCIe adapter, as shown in Figure 46 on page 67.
66 Power Systems: PCIe adapters for the 9008-22L, 9009-22A, or 9223-22H