IBM Power System 9008-22L Manual page 57

Figure 29. Releasing the cable management arm
b) Swing the cable management arm away from the system.
In the image, the inner cable management arm tab is shown on the left side as you are facing the
system from the rear. However, the cable management arm can also be installed so that the inner
cable management arm tab is on the right side of the system.
CAUTION: To avoid causing damage to the arm, open the cable management arm just long
enough to complete these repairs.
7. If removed, connect the cables or transceivers to the adapter.
8. If you are servicing a rack-mounted system, route the cables through the cable-management arm.
9. Using your labels, reconnect the power cords (A) to the system unit.
Fasten the power cords to the system using the hook-and-loop fasteners (B) as shown in Figure 30
on page 44.
Installing, removing, and replacing PCIe adapters in the 9008-22L, 9009-22A, or 9223-22H system 43