IBM Power System 9008-22L Manual page 34

Figure 15. Closing the cable management arm
10. Close the rack door at the rear of the system.
11. Choose from the following options:
• If you completed this procedure with the system power turned off, continue with step "12" on page
20.
• If you are using the AIX operating system, continue with step "13" on page 20.
• If you are using the IBM i operating system, continue with step "14" on page 21.
• If you are using the Linux operating system, continue with step "18" on page 21.
12. If the system power is turned off, complete the following steps:
a) Start the system. For instructions, see Starting a system (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/crustartsys.htm).
b) Continue with step "19" on page 21.
13. If you are using the AIX operating system, you must configure the adapter by completing the
following steps:
a) Install the AIX device drivers for the installed adapter.
For instructions, see Installing the AIX device driver software.
b) On the console, enter cfgmgr to configure the adapter.
c) Continue with step "19" on page 21.
20 Power Systems: PCIe adapters for the 9008-22L, 9009-22A, or 9223-22H