Barcode Settings - Agilent Technologies 1100 Series Reference Manual

Barcode Settings

The Barcode Settings dialog box is displayed when you select the Barcode
Settings button from the Hypersequence Parameters dialog box. It allows you to
specify the settings necessary to read your barcodes.
Checksum
In the Checksum group, you specify whether the checksum is activated or
deactivated.
If you enable the checksum, you may need to reconfigure the hand-held scanner, see
NO TE
"Configuring the Hand-held Barcode Reader"
Start/Stop Character
In the Start/Stop Character group, you specify whether a start/stop character is
transmitted or not.
If you enable the transmission of a start/stop character, you may need to reconfigure the
NO TE
hand-held scanner, see
Table 2
Table 2
Barcode Type
• Code 39
• Code 128
• Interleaved 2 of 5
• Codabar
1100 Series Sample Capacity Extension
"Configuring the Hand-held Barcode Reader"
shows the barcode types that are supported.
Supported Barcode Types
Checksum
Start/Stop Character
Checksum
Start/Stop Character
Checksum
Start/Stop Character
Checksum
Start/Stop Character
Working with the Sample Capacity Extension
on page 30.
Barcode Settings
Set to match barcode writer parameters
Set to match barcode writer parameters
Ignored (always activated)
Ignored (always deactivated)
Set to match barcode writer parameters
Ignored (always deactivated)
Ignored (always deactivated)
Set to match barcode writer parameters
4
on page 30.
61