Preliminary Adjustment Of The Well-Plate Handler Position - Agilent Technologies 1100 Series Reference Manual

Preliminary Adjustment of the Well-plate Handler Position

These adjustments are made by moving the Well-plate Handler arm and
gripper fingers manually. These actions do not damage the Well-plate Handler
mechanisms.
1 Turn off the power on the back panel of the Well-plate Handler.
2 Loosen the six adjusting screws holding the Well-plate Handler in position.
3 Place a plate in the rack R1.
4 Position the gripper arm above rack R1.
5 Move the arm down until it touches the plate.
6 Squeeze the gripper fingers so that they grip the plate.
7 Keeping the gripper fingers closed, raise the arm until the plate is clear of
8 Rotate the arm until it is positioned above the Automation Interface.
9 Lower the arm until the rack is placed on the transport position of the
10 Adjust the position of the Well-plate Handler until the plate is squarely and
11 Tighten the adjustment screws.
If you have fitted the optional rack extension, you must also adjust its lateral
position.
1 Loosen the three adjusting screws holding the rack extension in position.
2 Place a plate in the rack R1.
3 Position the gripper arm above rack R1.
4 Move the arm down until it touches the plate.
5 Squeeze the gripper fingers so that they grip the plate.
6 Keeping the gripper fingers closed, raise the arm until the plate is clear of
7 Rotate the arm until it is positioned above rack R5.
8 Lower the arm until the rack is immediately above the rack
1100 Series Sample Capacity Extension
the rack.
Automation Interface.
centrally positioned on the transport position of the Automation Interface.
the rack.
Installation 2
37