Stopping Your Dryer; Fabric Softener Sheets - Fisher & Paykel SmartLoad DE62T27GW1 Installation Instructions And User Manual

Using Your Dryer

9. Stopping Your Dryer

Your SmartLoad™ dryer can be stopped during any stage of the drying process, to allow you to
check on your load or add/remove clothes.
To do this, press START/PAUSE. There will be a slight delay
as the drum slows down and stops in the open position
(approximately 15 seconds). During the opening sequence, the
LID LOCKED light will flash, once the drum is stationary the
light will be extinguished, you can then open the lid.
Note:
If the cycle is interrupted before it progresses into COOL DOWN, parts of the drum may be hot.
To start your dryer again, press START/PAUSE.
10. Changing Cycles During Operation
If you wish to change the drying cycle you have chosen after the machine has already begun
drying, press your new cycle selection on the control panel. If the progress lights have begun to
advance through the cycle, you will need to turn the dryer off and start afresh.

11. Fabric Softener Sheets

If you want to use fabric softener sheets, you must ensure that they are labelled "dryer safe".
Always follow the instructions on the packaging. Do not place them in a dryer with warm clothes
as there is a chance the fabric softener may stain clothes.
Only use a softener sheet once, then discard it.
12. Beeps
At the end of the cycle, the dryer will beep to let you know that the load is finished. The drum
will automatically come to rest in the open position, allowing you to open the lid and remove
your load.
13. Finishing your Cycle Early
Normally SmartLoad™ will advance through the progress lights as it dries and
will switch off once it has completed COOL DOWN.
If you wish to finish your drying cycle early you can press AIR DRY to advance
it to this COOL DOWN mode.
The COOL DOWN mode means the elements will switch off and the clothes
are tumbled without heat. When SmartLoad™ senses the clothes are cool it
will automatically shutdown (this takes 2 – 10 minutes depending on the size
of your load).
Note:
The COOL DOWN mode is only activated if your dryer has progressed past the DRYING progress
light. If the DRYING progress light is still glowing and you press AIR DRY your dryer will switch
to the AIR DRY cycle and will dry for 80 minutes (the default AIR DRY setting). You can stop your
dryer at any stage by pressing START/PAUSE.
42