Table of Contents
Advertisement
Using your dryer
41
Stopping your dryer
Your AeroSmart dryer can be stopped during any stage of the
drying process, to allow you to check on your load or add/
remove clothes.
To do this, press START/PAUSE. There will be a slight delay
as the drum slows down and stops in the open position
(approximately 15 seconds). During the opening sequence,
the LID LOCKED light will flash, once the drum is stationary the
light will be extinguished, you can then open the lid. To start
Fig.48 Press Start/Pause
your dryer again, press START/PAUSE.
Note: If the cycle is interrupted before it progresses into COOL DOWN, parts of the drum may be hot.
Changing cycles during operation
If you wish to change the drying cycle you have chosen after the machine has already begun
drying, press your new cycle selection on the control panel. If the progress lights have begun to
advance through the cycle, you will need to turn the dryer off and start afresh.
Fabric softener sheets
If you want to use fabric softener sheets, you must ensure that they are labelled "dryer safe".
Always follow the instructions on the packaging. Do not place them in a dryer with warm
clothes as there is a chance the fabric softener may stain clothes.
Only use a softener sheet once, then discard it.
Beeps
At the end of the cycle, the dryer will beep to let you know that the load is finished. The drum
will automatically come to rest in the open position, allowing you to open the lid and remove
your load.
Finishing your cycle early
AeroSmart will advance through the progress lights as it dries and
will switch off once it has completed COOL DOWN.
If you wish to finish your drying cycle early you can press AIR DRY
to advance it to this COOL DOWN mode.
The COOL DOWN mode means the elements will switch off and
the clothes are tumbled without heat. When AeroSmart senses
the clothes are cool it will automatically shutdown (this takes 2
– 10 minutes depending on the size of your load).
Note: The COOL DOWN mode is only activated if your dryer has progressed past the DAMP
progress light flashing. If the DAMP progress light is still flashing and you press AIR DRY your
dryer will switch to the AIR DRY cycle and will dry for 40 minutes (the default AIR DRY setting).
You can stop your dryer at any stage by pressing START/PAUSE.
Hide quick links:
Advertisement
Table of Contents
