Venting - Fisher & Paykel SmartLoad DE62T27GW1 Installation Instructions And User Manual

Venting

The dryer exhaust must be vented to the outdoors. This will prevent the build up of lint and
moisture in the room in which it is located and reduce the risk of fire.
Exhaust ducting products can be purchased from your local Appliance store or Hardware store.
Never use plastic or metal foil flexible duct. This ducting can kink, sag, be punctured, reduce
airflow, extend drying times and affect dryer operation.
A minimum of 4 inch (100 mm) thick wall flexible metal or rigid galvanised metal duct must be
used. Using ducts larger than 4 inches (100 mm) diameter may result in more lint accumulating.
In Canada, the exhaust duct must be 4.02 inches (102 mm) in diameter.
Using straight rigid metal ducting will minimize lint accumulation. Thick wall flexible metal
ducting may be used but care must be exercised to avoid sharp bends which may squash the
duct and cause blockages.
Use duct tape to secure joints. Do not use screws or any other fastening device which will
extend into the duct, as they will collect lint.
Keep ducting as short and straight as possible. Do not exceed the maximum exhaust duct
lengths stated later in these installation instructions. The total length of flexible metal duct used
should be no longer than 94.5 inches (2.4 m).
Do not vent the dryer into any other duct, chimney or gas vent because accumulated lint and
other material is a potential fire hazard. Do not vent the dryer into any ceiling, attic, crawl space,
under-floor space, wall cavity, window well or any other concealed cavity that will accumulate
lint.
Fit an exhaust hood with a swing-out damper to the outside
end of the exhaust duct to prevent back drafts and entry of wild
life. Never use exhaust hoods with a magnetic damper. The hood
should have at least 12 inches (305 mm) clearance between the
bottom of the hood and the ground or other obstruction. The
hood opening should point down. Never install a screen over
the exhaust outlet.
14
WARNING
The dryer must be vented to the outdoors.
Use rigid or thick wall flexible metal exhaust duct only.
Do not use a plastic exhaust duct.
Do not use a metal foil exhaust duct.
Failure to follow these instructions can result in death or fire.
Fire Hazard
12" (305mm)