Table of Contents
Advertisement
Using
you
d yer
Stopping you_ d_ye_
Your AeroSmart dryer can be stopped
dunng any stage of the
drying
process, to allow you to check on your load or add/
remove clothes.
To do this, press START/PAUSE There will be a slight delay
as the drum slows down and stops in the open position
(approximately
15 seconds). Dunng the opening
sequence,
the LID LOCKED light will flash, once the drum is stationary
the
light will be extinguished,
you can then open the Iid.To start
your dryer again, press START/PAUSE.
£g.48 Pres Start/Pc, use
Note: If the cycle is interrupted
before it progresses into COOL DOWN, parts of the drum may be hot.
Changing
cycles during
operation
If you wish to change the drying cycle you have chosen after the machine
has already begun
drying, press your new cycle selection
on the control panel. If the progress lights have begun to
advance through the cycle, you will need to turn the dryer off and start afresh.
Fabric softener
sheets
If you want to use fabric softener sheets, you must ensure that they are labelled "dryer safe"
Always follow the instructions
on the packaging.
Do not place them in a dryer with warm
clothes as there is a chance the fabric softener may stain clothes.
Only use a softener
sheet once, then discard it.
Beeps
At the end of the cycle, the dryer will beep to let you know that the load is finished. The drum
will automatically come to rest in the open position, allowing you to open the lid and remove
your load.
Finishing
your cycle early
AeroSmart will advance through
the progress lights as it dries and
will switch off once it has completed
COOL DOWN.
If you wish to finish your drying cycle early you can press AIR DRY
to advance it to this COOL DOWN mode.
The COOL DOWN mode means the elements
will switch off and
the clothes are tumbled
without
heat. When AeroSmart senses
the clothes are cool it will automatically
shutdown
(this takes 2
- 10 minutes depending
on the size of your load).
Cee/ing
Note: The COOL DOWN mode is only activated
if your dryer has progressed
past the DAMP
progress light flashing.
If the DAMP progress light is still flashing and you press AIR DRY your
dryer will switch to the AIR DRY cycle and will dry for 40 minutes (the default
AIR DRY setting).
'_ou can stop your dryer at any stage by pressing START/PAUSE
Advertisement
Table of Contents
