Mounting Dryer On Wall - Fisher & Paykel DE4060M1 Installation Instructions Manual

Mounting Dryer on Wall

1. Determine the position of the dryer on the wall and
mark the bracket position. A minimum of 50mm is
needed between the top of the dryer and the
ceiling for ease of installation. If mounting above a
washing machine, allow sufficient room to open the
lid of the washer. Refer to 'Inverted Wall
Mounting' for lid clearances.
2. Fix the wall hanging brackets to the wall securely,
ie into the stud. If the studs are too far apart, fit a
timber slat to the studs and then mount the
brackets to the slat. If a slat is used install a
second slat behind the spacers to ensure the dryer
is horizontal. The distance between the centre of
each bracket is 555mm (A).
3. To install the hooks onto the dryer, remove one
screw from each side (B), reuse these screws with
two more (each side) from the kit to fasten the
hooks in place.
4. Remove plastic plugs from the back of the dryer
and screw the spacers provided in place (C).
5. With assistance, mount the dryer on the wall
brackets.
6. Fit inverted control panel over the existing panel.
7. Adjust the display to read correctly on an inverted
panel:
◦ For DE7060M and DE5060M press and hold
the 'Keylock' and 'Heavy' buttons for three
seconds.
◦ For DE4060M press and hold the 'Keylock'
and 'Air Dry' buttons for three seconds.
◦ The dryer will beep to indicate you have made
a correct selection, and the display will change
after three seconds.
◦ Repeat the same steps to return the panel to
the factory setting.
Before a rear venting option is installed the dryer must be changed from the front venting factory setup. Remove the
outlet grille from the front left-hand side and replace with the outlet cover from the rear left-hand side. These covers
should be gently pried at the sides to prevent damage.
https://producthelp.fisherpaykel.com/au/Dry/Dryers/Vented/DE4060M1/User_Guide_DE4060M1/03_Installation_Instructions
Updated: Sun, 27 Aug 2023 10:37:02 GMT
Powered by
7