Making A Copy Using The Document Glass - Sharp MX-2314N Operation Manual

MAKING A COPY USING THE DOCUMENT GLASS

To make a copy of a book or other thick original that cannot be scanned with the automatic document feeder, open the
automatic document feeder and place the original on the document glass. This section explains how to make a copy
(1-sided copy of a 1-sided original) using the document glass.
1
Do not place any objects under the original size detector. Closing the automatic document feeder with an object
underneath may damage the original size detector plate and prevent correct detection of the document size.
Colour Mode
Full Colour
Exposure
Auto
2
Copy Ratio
Original
100%
Depending on the size of the placed original, there may be cases where the same size of paper as the original is not
selected automatically. In this event, change the paper size manually.
Original size
detector
Special Modes
2-Sided Copy
Plain
A4
Output
1. A4
A4R
2.
File
B4
3.
A3
4.
Quick File
Paper Select
Auto Auto
A4
A4
Preview
Plain
Open the automatic document feeder,
place the original face down on the
document glass, and then gently close
the automatic document feeder.
Document glass scale
mark
A5
(5-1/2" x 8-1/2")
B5
A4 (8-1/2" x 11")
• Align the corner of the original with the tip of the arrow mark
on the document glass scale.
• Place the original in the appropriate position for its size as
shown above.
• After placing the original, be sure to close the automatic
document feeder. If left open, parts outside of the original will
be copied black, causing excessive use of toner.
Check the paper to be used and the
colour mode.
Make sure that the desired paper (tray) and colour mode are
selected.
• To change the paper (tray), touch the [Paper Select] key.
☞
PAPER TRAYS
• To change the colour mode, touch the [Colour Mode] key.
☞
COPY COLOUR MODES
2-14
COPIER
Document glass scale
mark
B5R
A4R (8-1/2" x 11"R)
B4 (8-1/2" x 14")
A3 (11" x 17")
(page 2-11)
(page 2-21)
Contents