Table of Contents
Advertisement
put.
• Press the button 11 or 12 (Figure 9.11) to
confirm the value entered and activate the
function. (Figure 9.16).
Figure 9.16
• To exit the chimney sweeper, reset the value
of parameter P06 to 00 or wait 15 minutes
with the boiler off (OFF).
• Turn the boiler off by pressing the 16 but-
ton (Figure 9.11) until the message OFF ap-
pears on the LCD display (Figure 9.17).
Figure 9.17
9.12 Settings for changing the control
board
When the control board is replaced, it must be
configured for the exact boiler type.
• Enter "programming mode" by holding down
buttons 16 and 17 for 5 seconds at the same
time (Figure 9.18). The code P00 appears
on the display, indicating entry into "parame-
ter P00" (Figure 9.19).
MAINTENANCE
RESET
bar
RESET
bar
17
11
12
Figure 9.18
Figure 9.19
• Scroll through the various parameters using
11 or 12 until the LCD display shows the
message Cod, indicating entry into "param-
eter Cod" (Figure 9.20), and then displays
three dashes "- - -".
Figure 9.20
• Press the 15 button to set "2 - -", then press
11 to confirm the 1 and go to the next seg-
ment.
• Press the 15 button to set "2 7 -", then press
11 to confirm the 9 and go to the next seg-
ment.
• Press the 15 button to set "2 7 5", then press
11 to confirm the 8 and go back to the list of
parameters.
• The code A00 appears on the display, in-
16
15
14
RESET
bar
RESET
bar
- 61 -
Advertisement
Table of Contents
