Heat & Glo ST-550TM-IPI Owner's Manual page 55

B. Vent Components Diagrams (continued)
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm)
the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a
DVP-HSM-B will be required.
15-1/8 in.
(384 mm)
12 in.
(305 mm)
SLP-DCF-BK
Ceiling Firestop
Black
SL-2DVP
Adapter
SLP-FLEX-TRAP
Horizontal
Termination Kit
Figure 16.4 SLP Series Vent Components
8 in.
(203 mm)
SLP-TRAP
Horizontal Termination Cap
SLP-CCS-BK
Cathedral Ceiling
Support Box-Black
SLP90
Heat & Glo • ST-550TM-IPI • 2142-900 Rev. S • 3/20
Heat
Shield
Term Cap
Max
Effective
Trap1
Length
Trap2
DVP-2SL
Adapter
DVP-FBHT
SL-2DVP
ASSEMBLY
Minimum Maximum
Effective Length Effective Length
3-1/8 in. 4-3/4 in.
79 mm 121 mm
5-1/4 in. 9-1/4 in.
133 mm 235 mm
SLP-WT-BK
Wall Thimble-Black
SLP-TVHW
Vertical
Termination Cap
DVP-FBHT
55