Removing Or Replacing The Sensorflash Microsd Card - Siemens SITRANS F Series Operating Instructions Manual

Note
Hot swapping the battery
After removing the battery FST090 stays on for around 30 s. With a second battery you can hot
swap the battery without connecting the Auxiliary Power Adapter.
A second battery can be ordered with order number: A5E50084513 under PIA Life Cycle Portal
(https://www.pia-portal.automation.siemens.com).
1. Push down the latch on the lid.
2. Open up the lid.
3. Slide out the battery.
4. Replace the battery in reverse order.
10.3.2

Removing or replacing the SensorFlash microSD card

Before you remove the SensorFlash microSD card
• Make sure to eject the SensorFlash microSD card through menu 3.7.1 or by turning data
logging off (menu 3.7.5.1).
Removing or replacing the SensorFlash microSD card
Figure 10-1
NOTICE
Potential loss of data!
Eject the SensorFlash microSD card before removing it. Otherwise your last data point will be
corrupted.
SITRANS FST090
Operating Instructions, 11/2021, A5E50387341-AA
SensorFlash microSD card removal
Service and maintenance
10.3 Maintenance and repair work
71