Table of Contents
Advertisement
78
Seats and Stowage
Front seats
– You can switch on and adjust the heaters of the driver and
front passenger seats by turning the rotary controls
⇒ page 77, fig.
60, respectively.
Rear seats
– You can switch on and adjust the heaters of the left and right
rear seats by turning the rotary controls
⇒ page 77, fig.
61, respectively.
If the rotary controls are in the 0 position, the seat heater is switched off.
When the seat heater is switched on, the numerical marking of the rotary
control is illuminated. The control range extends from 1 to 5.
Caution
•
You should not kneel on the seats and avoid applying pressure at
specific points in order to avoid damaging the heating elements of the seat
heaters.
•
Do not clean the seats moist ⇒ page 194.
Note
The seat heating should only be switched on when the engine is running.
This has a significant effect of saving on the battery capacity.
Pedals
You should use only footmats which do not obstruct the movement of the
pedals and have an anti-slip protection.
Operation of the pedals must not be hindered!
A
A
and
1
2
•
the brake system.
•
the area of the pedals in order to ensure that all the pedals can be
A
A
and
A
B
fully depressed and are able to return unobstructed to their initial
position - risk of accident!
•
pedals. You would then no longer be able to apply the brakes,
operate the clutch or accelerator - risk of accident!
Luggage compartment
Loading the luggage compartment
Please observe the following in the interest of having good
handling characteristics of your vehicle:
– Distribute the items of luggage as evenly as possible.
– Place heavy objects as far forward as possible.
– Attach the items of luggage with the safety net* or with
tensioning straps attached to the lashing eyes ⇒ page 79.
WARNING
Greater pedal distances may be needed when there is a fault in
Do not place any footmats or other additional floor coverings in
There must be no objects on the floor which could roll under the
Advertisement
Table of Contents
