Release
›
Pull the handbrake lever up slightly and at the same time push in the locking
button
» Fig.
241.
›
Move the lever right down while pressing the lock button.
The handbrake warning light
lights up in the instrument cluster when the
handbrake is applied and the ignition is on.
A warning signal sounds if the vehicle is inadvertently driven off with the hand-
brake applied. The handbrake warning is activated if the vehicle is driven at a
speed of over 5 km/h for more than 3 seconds.
WARNING
Disengage the handbrake completely. A handbrake which is only partially
disengaged can result in the rear brakes overheating. This can have a nega-
tive effect on the operation of the brake system – risk of accident!
Note
Push the armrest cover all the way back to the stop before applying the hand-
brake» page
86.
Parking
Read and observe
on page 202 first.
When stopping and parking, look for a place with a suitable surface
Only carry out the activities while parking in the specified order.
›
Bring the vehicle to a stop and depress the brake pedal.
›
Firmly apply the handbrake.
›
For vehicles with automatic transmission, place the selector lever in the P
position.
›
Switch off the engine.
›
For vehicles with manual transmission, select 1st gear or reverse gear R.
›
Release the brake pedal.
WARNING
The exhaust system components can become very hot. Therefore, never
■
stop the vehicle at places where the underside of your vehicle can come in-
to contact with flammable materials such as dry grass, undergrowth,
leaves, spilled fuel or such like. - Risk of fire and serious injury can occur!
When leaving the vehicle, never leave people who could, for example, lock
■
the vehicle or release the brake, unattended in the vehicle - risk of accident
and injury!
Manual gear changing and pedals
Introduction
CAUTION
When stopping on a slope, never try to hold the vehicle using the accelerator
pedal – this may lead to gear damage.
Manual gear changing
»
.
Read and observe
The gearshift pattern for the individual gear positions is shown on the gear lev-
er
» Fig.
242.
The gear shift indicator should be observed when changing gear
Always depress the clutch pedal all the way down. This prevents uneven wear
on the clutch.
Reverse gear is engaged
›
Stop the vehicle.
Fig. 242
The shift pattern
on page 203 first.
Starting-off and Driving
» page
50.
203