Table of Contents
Advertisement
104
Heating and air conditioning system
Note
•
If the windscreen is misted up, turn the air distributor regulator
position
. It is not possible to operate the recirculated air mode,
however, in this position.
•
The whole heat output will be needed to unfrost the windscreen and
side windows. No warm air will be fed to the footwell. This can lead to
restriction of the heating comfort.
•
If the air conditioning system has not been switched on for a lengthy
period, odours may be produced at the evaporator because of deposits.
Switch the air conditioning system on at least once a month for approxi-
mately 5 minutes at the highest blower stage - also during the cold season
of the year - in order to remove such odours. Also open a window for a
short time.
•
Please refer to the information regarding recirculated air mode
⇒ page 105.
Setting air conditioning system
Recommended settings of air conditioning controls:
Defrosting the windscreen and side windows
•
A
Turn control dial
A
•
A
Blower switch
in position 4
B
•
Turn the air distribution control
•
Close the air outlet vents 3
•
Open air outlet vents 4
side window.
⇒ page 103, fig. 99
to the right up to the stop
A
into the position
C
⇒ page 106, fig. 100
and point towards the
Keeping winscreen demisted
We recommend that you use the following setting in cases where the
A
into
C
windows are misted up more than usual (e.g. when it is raining):
•
A
Blower switch
B
•
Turn the air distribution control
•
Close the air outlet vents 3
•
Open air outlet vents 4 and point towards the side window
•
Switch on the air conditioning system using switch
Warming up the inside of the vehicle as rapidly as possible
•
Turn control dial
•
A
Blower switch
B
•
Turn the air distribution control
•
Open air outlet vents 3 and 4
•
we recommend that you press the switch
mode - for a short time
Heating the vehicle to a comfortable temperature
We recommend the following setting once the windows are no longer
misted up and the desired teperature has been reached:
•
A
Control dial
at the desired heat output
A
•
A
Blower switch
B
•
Turn the air distribution control
•
Close the air outlet vents 3
•
Open the air outlet vents 4
•
Set the air distribution regulator
windscreen gets misted up again, as required.
Cooling down the inside of the vehicle as rapidly as possible
•
Turn the control dial
•
A
Blower switch
B
in position 2
A
into the position between
C
A
to the right up to the stop
A
in position 3 or 4
A
into the position
C
A
- recirculated air
D
in position 1 or 2
A
into the position
C
A
between positions
C
A
to the left up to the stop
A
in position 3 or 4
and
A
AC
E
and
, if the
Advertisement
Table of Contents
