Korg Soundlink DRS OASYS PCI User Manual page 21

Using the OASYS PCI
3.
For instance, setting the Low Velocity to 100 and the High Velocity to 128 will make
the Program play only when the velocity is fairly high.
When the High/Low Key and Velocity parameters are selected, you can press and
hold the Shift key to edit the values by playing notes on your MIDI controller.
You can create velocity splits using as many different Programs as you like.
Auditioning Multis through a specific Output Bus
All of Korg's factory preset Multis are set to use the Analog output as the Master
Output Bus. If you'd like to audition these Multis through another output, such as
S/PDIF or ADAT 1-2, you can do so by setting up the Preferences as described
below.
1.
The Preferences window will appear.
2.
3.
4.
This will automatically set the Master Output Bus to the default when a Multi is
opened. Note that this will also edit any custom Multis that you've made yourself.
Reset Master Output Bus can change DSP requirements
If a Multi uses multiple Output Buses, changing the Master Output Bus may
sometimes require the Programs and Effects to be re-arranged within the DSPs.
This may either increase or decrease the effective amount of DSP processing power
available.
In extreme cases, if the Multi was already using up almost all of the available DSP
processing power, it is possible that changing the Master bus may put things over
the edge, making the Multi too big to be played. If this happens, disable the
"Reset Master Output Bus" option, or take one of the other measures described
under "Managing Resources" on page 60.
Using the Connect and Disconnect commands
Whenever you add or remove a Program or Effect, copy a Program or Effect
between channels, add or remove a Patch from a Program, add a new Multisample
or Sample, or change the Input Type of a Channel, the DSP code running in the
OASYS PCI is changed. Normally, the OASYS PCI will compute these changes, and
automatically download the new code and/or Sample data to the DSPs. This
process may take a few seconds.
If you are making many edits of this sort, such as adding several new Effects or
Multisamples at once, the Connect and Disconnect commands can speed things up.
OASYS PCI
Set the High/Low Velocity parameters so that each Program is active for
only a specific velocity range.
Select Preferences from the Edit menu.
Select the General tab.
Under Multi Defaults, set the Master Output Bus to the desired output.
Check the "Reset Master Output Bus When Opening Multis" option.
Using Multis
17