Korg Soundlink DRS OASYS PCI User Manual page 19

Using the OASYS PCI
The Effects-Only Program will replace any previously loaded Insert Effects.
Note that unlike normal Programs, loading an Effects-Only Program will not
change the input to the Channel. If the Channel already contained a Program, the
original Program's Patches will play through the new Effects. If the Channel's input
was an Audio Input or a Stream, the Input Type will not change, and the audio will
play through the new Effects.
Effects-Only Programs can only be used on Mixer Channels
Effects-Only Programs can only be used on Mixer Channels; they cannot be loaded
directly into Send Busses or Output Busses.
As a workaround, you can load an Effects-Only Program onto a Mixer Channel,
and then copy the individual Effects onto the desired Send Bus or Output Bus.
Using Insert, Send, and Output Bus Effects
The Multi's Effects routing capabilities are very powerful–so powerful that they
have their own section in this manual! See the section titled "Using Effects,"
beginning on page 23, for more details.
Removing a Program or Effect from a Multi
To remove a Program or Effect from a Multi:
1.
2.
The Program or Effect will be removed from the Multi.
When deleting several Programs or Effects in a row, you may wish to use the
Connect and Disconnect commands, as described on page 17.
Copying Programs or Effects
You can copy any Program or Effect, including all Control Panel settings, from one
Channel to another, or from one Multi to another. Simply use drag-and-drop, or use
the Copy and Paste commands in the Edit menu. To copy from one Multi to
another, open both Multis and drag-and-drop between them.
When copying several Programs or Effects in a row, you may wish to use the
Connect and Disconnect commands, as described on page 17.
Creating splits and layers of two or more Programs
You can use Multis to create complex keyboard and velocity splits and layers
between two or more Programs. Note that Patches can also be split and layered
within a single Program, which interacts with the Multi as shown below.
OASYS PCI
Select the Program clicking on its name in the Mixer or Channel Parameters
window. Or, select the Effect by clicking on its name in the Mixer, Send
Busses, or Output Busses window.
Press the Delete key.
Using Multis
15