Korg Soundlink DRS OASYS PCI User Manual page 125

Reference
VERY IMPORTANT: The sample rate affects the processing power available to the
OASYS PCI. You'll get about 8% more processing power for synthesizers and/or
effects at 44.1kHz than at 48kHz.
44.1 kHz. The internal sample rate will be set to 44.1kHz. Also, the S/PDIF sample
rate information will be set to 44.1kHz.
48 kHz. The internal sample rate will be set to 48kHz. Also, the S/PDIF sample rate
information will be set to 48kHz.
Clock source
When connecting multiple digital audio devices–such as the OASYS PCI, an ADAT
system, and a S/PDIF device–it is important that the word clocks of the devices be
locked together. If the clocks are not locked, the audio may be marred by pops and
clicks. The OASYS PCI can lock to incoming clocks from any of its digital inputs, or
it can generate its own clock. For more information, see "A few words on word
clock," at the end of the System Configurations section of the Installation Guide.
You may need to select different clock sources from time to time, depending on
what you are currently doing with the OASYS PCI; see the "System
Configurations" section of the Installation Guide for details.
ADAT. The ADAT optical input will provide the master word clock.
S/PDIF. The S/PDIF input will provide the master word clock.
Word Clock. The BNC word clock input will provide the master word clock.
Internal. The OASYS PCI's internal clock will be the master. With this setting, the
Sample Rate parameter, described above, controls the clock.
Master Fine Tune
+/- 100 cents. This allows you to make small adjustments to the global pitch of the
OASYS PCI, in cents. A cent is 1/100 of a semitone.
Sample Tab
This page contains sample-related preferences.
Default Multisample File
This parameter selects the Multisample which will appear in a new, blank PCM
Patch.
Choose... button
To select any Multisample file on disk, press the Choose button; a standard file
dialog will appear, allowing you to select the file to use.
Set to (none) button
If you would prefer not to load any Multisample when opening a new, blank PCM
Patch, press this button. The Default Multisample will be set to (none).
OASYS PCI
Preferences
121