Setting The Projector Id - Epson PowerLite G5000 User Manual
Epson powerlite g5000: user guide
Hide thumbs
Also See for PowerLite G5000:
- Quick reference card (7 pages) ,
- Declaration of conformity (4 pages) ,
- Installation handbook (3 pages)
Table of Contents
Advertisement
Operating Two or More Projectors With
the Remote Control
If you're using more than one projector, you can control all the
projectors—or just selected ones—by using the projector ID system.
To operate a projector, set the remote control's ID to match that of
the projector. Or you can control all the projectors at once by setting
the remote control's ID to zero.
Setting the Projector ID
The projector's default ID is set to Off. This lets it respond to
commands from any remote control. To change the ID, follow these
steps:
1. Press the
button on the remote control. You see the
Menu
projector's menu screen.
2. Select
, then
Extended
3. Use the
pointer button to highlight the new ID, and press
to select it.
Enter
4. When you're done, press
.
Projector ID
to exit.
Menu
Presenting With the Remote Control
43
Advertisement
Table of Contents
