Connecting To A Wired Network - Epson PowerLite 825 User Manual

Using the Projector on a Network
54
Guide for instructions on installing the EMP NS Connection
software. The EasyMP Operation Guide also contains instructions on
using the software to project over the network.

Connecting to a Wired Network

With a shielded, Category-5 Ethernet cable, you can connect the
projector to your network and configure it with an IP address. You
can then project from multiple computers on your network without
changing any cables.
1. Connect the projector to your network using a commercially
available 100BaseTX or 10BaseT network cable. Connect the
cable to the port on the projector as shown.
LAN
2. Connect the other end to your Ethernet hub or router.
3. Point the remote control at the projector and press the Ppower
button.
4. Press the button on the remote control to select network as
LAN
the source.
Network cable