Memory Module Replacement; Remove A Memory Module - Lenovo ThinkSystem SR530 Maintenance Manual

Step 1. Ensure that the drive tray handle is in the open position. Slide the drive into the drive bay until it
snaps into position.
Step 2. Close the drive tray handle to lock the drive in place.
Step 3. Continue to install additional simple-swap drives if necessary.
After you have installed all drives:
1. Reinstall the security bezel. See "Install the security bezel" on page 55.
2. Power on the server.
3. Use the Lenovo XClarity Provisioning Manager to configure the RAID if necessary. For more information,
see:
http://sysmgt.lenovofiles.com/help/topic/LXPM/RAID_setup.html

Memory module replacement

Use this information to remove and install a memory module.

Remove a memory module

Use this information to remove a memory module.
"Read the
installation
Guidelines" on
page 45
Attention:
• Disconnect all power cords for this task.
• Memory modules are sensitive to static discharge and require special handling. In addition to the standard
guidelines for "Handling static-sensitive devices" on page 48:
– Always wear an electrostatic-discharge strap when removing or installing memory modules.
Electrostatic-discharge gloves can also be used.
– Never hold two or more memory modules together so that they touch. Do not stack memory modules
directly on top of each other during storage.
– Never touch the gold memory module connector contacts or allow these contacts to touch the outside
of the memory module connector housing.
– Handle memory modules with care: never bend, twist, or drop a memory module.
Before removing a memory module:
1. Remove the top cover. See "Remove the top cover" on page 57.
2. Remove the air baffle. See "Remove the air baffle" on page 60.
To remove a memory module, complete the following steps:
Watch the procedure. A video of the removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-AQrHuDWK6L3KtHWc6maY_O
• Youku:
http://list.youku.com/albumlist/show/id_50437162
ThinkSystem SR530 Maintenance Manual
84
"Power off
the server
for this task"
on page 14
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 48