Table of Contents
Advertisement
Riser card replacement
Use this information to remove and install a riser card.
Your server comes with one of the following riser assembly configurations:
Configuration 1
• Riser 1 assembly: LP + LP
• Riser 2 assembly: LP (available on some models)
For information about the supported riser cards for each configuration, see "Rear view" on page 21.
There are three types of riser assemblies. The removal and installation procedure of the riser card is similar
for all types of riser assemblies. The following procedures are based on the riser assembly in configuration 2.
Remove a riser card
Use this information to remove a riser card.
"Read the
installation
Guidelines" on
page 45
To remove a riser card, complete the following steps:
Watch the procedure. A video of the removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-AQrHuDWK6L3KtHWc6maY_O
• Youku:
http://list.youku.com/albumlist/show/id_50437162
Note: The riser assembly you want to remove might be different from the illustrations below, but the removal
method is the same.
Step 1.
Remove the top cover. See "Remove the top cover" on page 57.
ThinkSystem SR530 Maintenance Manual
110
Configuration 2
• Riser 1 assembly: LP + FHHL
"Power off
the server
for this task"
on page 14
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 48
Advertisement
Table of Contents
