Table of Contents
Advertisement
Figure 58. Memory module installation
Step 1.
Open the retaining clips on each end of the memory module slot.
Attention: To avoid breaking the retaining clips or damaging the memory module slots, open and
close the clips gently.
Step 2.
Align the memory module with the slot, and gently place the memory module on the slot with both
hands.
Step 3.
Firmly press both ends of the memory module straight down into the slot until the retaining clips
snap into the locked position.
Note: If there is a gap between the memory module and the retaining clips, the memory module
has not been correctly inserted. In this case, open the retaining clips, remove the memory module,
and then reinsert it.
After installing a memory module, complete the parts installation. See "Complete the parts replacement" on
page 144.
.
Chapter 3
Hardware replacement procedures
91
Advertisement
Table of Contents
