Table of Contents
Advertisement
Install the top cover
Use this information to install the top cover.
"Read the
installation
Guidelines" on
page 45
Before installing the top cover:
1. Ensure that all cables, adapters, and other components are installed and seated correctly and that you
have not left loose tools or parts inside the server.
2. Ensure that all internal cables are correctly routed. See "Internal cable routing" on page 32.
3. If you are installing a new top cover, attach the service label to the new top cover first if necessary.
Note: A new top cover comes without a service label attached. If you need a service label, order it
together with the new top cover. The service label is free of charge.
To install the top cover, complete the following steps:
Watch the procedure. A video of the installation process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-AQrHuDWK6L3KtHWc6maY_O
• Youku:
http://list.youku.com/albumlist/show/id_50437162
Figure 33. Top cover installation
Note: Before you slide the top cover forward, ensure that all the tabs on the top cover engage the chassis
correctly. If the tabs do not engage the chassis correctly, it will be very difficult to remove the top cover later.
Step 1.
Ensure that the cover latch is in the open position. Lower the cover onto the chassis until all tabs on
both sides of the cover engage with the guides on both sides of the chassis.
Step 2.
Pivot the cover latch and slide the cover forward until the cover snaps into position. Ensure that the
cover latch is completely closed.
Step 3.
Use a screwdriver to turn the cover lock to the closed position.
"Power off
the server
for this task"
on page 14
Chapter 3
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 48
.
Hardware replacement procedures
59
Advertisement
Table of Contents
