Battery Installation And Charging - AT&T TL90076 User Manual

Getting started

Battery installation and charging

Install the battery, as shown on pages 7 and 8. Once you have
installed the battery, the screen indicates the battery status
(see the following table). If necessary, place the handset in
the telephone base or charger to charge the battery. For best
performance, keep the handset in the telephone base or charger
when not in use. The battery is fully charged after 11 hours
of continuous charging. See the table on page 37 for battery
operating times.
If the screen is blank or shows Place in charger and a flashing ,
you need to charge the handset without interruption for at
least 30 minutes to give the handset enough charge to use the
telephone for a short time. When the battery is low, the handset
shows Low battery and a flashing . If you are on a call in low
battery mode, the handset beeps every minute.
The following table summarizes the battery charge indicators and
actions to take.
Battery indicators
The screen is blank or
shows Place in charger
and flashes.
The screen shows
Low battery and
flashes.
The screen shows
HANDSET X.
Battery status
The battery has no or
very little charge. The
handset cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
6
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone
base or charger when not
in use.