Installation - Siemens SIMEAS R-PMU Manual

14.2.1

Installation

There are two housing sizes:
ZE 8/16 (10-inch housing)
ZE 32/64 (19-inch housing)
The device can be operated at the front side. All connections (except for the COM S service
interface) are located at the rear panel.
The SIMEAS R-PMU can be delivered for panel flush mounting, panel surface mounting
(surface-mounted housing) or for 19-inch mounting.
With ZE 32/64 design, every SIMEAS R-PMU housing is equipped with a special frame for
fastening the housing in a 19-inch rack using four screws.
Panel flush mounting
With panel flush mounting, the corresponding panel cut-out must be made in the corresponding
panel first. The installation into the cut-out can be done without any further installation material
by fastening the SIMEAS R-PMU using the appropriate fastening materials (4 screws) to the
panel. The external bores of the housing's mounting stop are used for this purpose (see
dimensional drawing in Chapter 8.2).
Panel surface mounting
With panel surface mounting (surface-mounted housing), the surface-mounted housing must
only be attached to the intended mounting position using appropriate fastening material
(depending on the surface). Four mounting plates at the corners of the housing are used for
fastening. For detailed fastening dimensions, please refer to the attached documents for the
surface-mounted housing.
Installation in a cabinet
Devices delivered in a cabinet are complete with internal wiring and the connections usually
mounted on terminal strips.
The D-SUB connectors, the RJ45 Ethernet connector, the connection modules (cubic plug) and
the screw-threads for the installation of metal levers for cable clamping and shield contact are
provided at the rear of the 7XP20 housing.
Extensions
If communication components are extended, please observe the notes in Chapter 14.3.
The dimensions of the devices and the specifications regarding mounting bores and the panel
cut-out can be found in the dimensional drawings in Chapter 15.2. For weights and
environmental conditions, please refer to the Technical Data.
Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012
14.2 Installation and Connection
189
14