Operational Safety; Maintenance Information - Xerox Nuvera 100 Getting Started Manual

Operational Safety

Maintenance Information

Xerox Nuvera Getting Started Guide
Your Xerox equipment and supplies were designed and tested to meet
strict safety requirements. These include safety agency examination,
approval, and compliance with established environmental standards.
Your attention to the following safety guidelines will help ensure the
continued safe operation of your Xerox Nuvera Printer:
Use the materials and supplies specifically designed for your Xerox
Nuvera Printer. The use of unsuitable materials may result in poor
performance of the machine and possibly a hazardous situation.
Follow all warnings and instructions that are marked on or supplied
with the machine.
Place the machine in a room that provides adequate space for
ventilation and servicing.
Place the machine on a level, solid surface (not on a thick pile carpet)
that has adequate strength to support the weight of the machine.
Do not attempt to move the machine. A leveling device that was
lowered when your machine was installed may damage the carpet or
floor.
Do not set up the machine near a heat source.
Do not set up the machine in direct sunlight.
Do not set up the machine in line with the cold airflow from an air
conditioning system.
Do not place containers of coffee or other liquid on the machine.
Do not block or cover the slots and openings on the machine.
Do not attempt to override any electrical or mechanical interlock
devices.
: Be careful when working in areas identified with this
WARNING
warning symbol. These areas may be very hot and should not be
touched.
If you need any additional safety information concerning the machine or
materials, contact your Xerox representative.
Any operator product maintenance procedures will be described in the
user documentation supplied with the product.
Do not carry out any maintenance on this product which is not
described in the customer documentation.
: Do not use aerosol cleaners. Aerosol cleaners can be
WARNING
explosive or flammable when used on electromechanical equipment.
Use supplies and cleaning materials only as directed in the Operator
section of this manual.
7