Laser Safety - Xerox Nuvera 100 Getting Started Manual

Laser Safety

North America
Europe EU
6
This product complies with safety standards and is certified as a Class
1 Laser product under the Center for Devices and Radiological Health
(CDRH) of the United States Food and Drug Administration (FDA)
implemented regulations for laser products. This product complies
with FDA performance standards for laser products except for
deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
These regulations apply to laser products marketed in the United
States. The label on the machine indicates compliance with CDRH
regulations and must be attached to laser products marketed in the
United States. This product does not emit hazardous laser radiation.
: Use of controls or adjustments or performance of
WARNING
procedures other than those specified herein may result in hazardous
exposure of laser light.
Since radiation emitted inside this product is completely confined
within the protective housing and external covers, the laser beam
cannot escape from the machine during any phase of the user
operation.
This product contains laser-warning labels. These labels are intended
for use by the Xerox Service Representative and are placed on or
near panels or shields that require special tools for removal. Do not
remove any of the panels. There are no operator serviceable areas in
these covers.
This product complies with IEC's safety standard 60825-1 (Edition
1.2) issued August 2001.
The equipment complies with laser product performance standards
set by governmental, national, and international agencies as a Class 1
Laser Product. It does not emit hazardous radiation, as the beam is
totally enclosed during all phases of customer operation and
maintenance.
: Use of controls or adjustments or performance of
WARNING
procedures other than those specified herein may result in hazardous
radiation exposure.
This product contains laser-warning labels. These labels are intended
for use by the Xerox Service Representative and are placed on or
near panels or shields that require special tools for removal. Do not
remove any of the panels. There are no operator serviceable areas
inside these covers.
If you need additional safety information concerning the product or
Xerox supplied materials, you may call the following number:
+44 (0) 1707 353434
Xerox Nuvera Getting Started Guide