Radio Frequency Emissions - Xerox Nuvera 100 Getting Started Manual

Radio frequency emissions

FCC in the USA
In Canada (ICES-003)
Regulatory information for RFID
Safety extra low voltage approval
2
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the Federal
Communications Commission (FCC) Rules. These limits are designed
to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct
the interference at his/her own expense.
Changes or modifications to this equipment not specifically approved
by the Xerox Corporation may void the user's authority to operate this
equipment.
: Shielded cables must be used with this equipment to
WARNING
maintain compliance with FCC regulations.
This Class 'A' digital apparatus complies with Canadian ICES-003.
Cet appareil numèrique de la classe 'A' est conforme á la norme
NMB-003 du Canada.
This product generates 13.56 MHz using an Inductive Loop System
as a Radio Frequency Identification device (RFID). This RFID device
complies with the requirements specified in FCC Part 15, Industry
Canada RSS-210, European Council Directive 99/5/EC, and all
applicable local laws and regulations.
Operation of this device is subject to the following two conditions: 1)
this device may not cause harmful interference, and 2) this device
must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications to this equipment not specifically approved
by Xerox Corporation may void the user's authority to operate this
equipment.
This Xerox Nuvera Printer Family is in compliance with various
governmental agencies and national safety regulations. All system
ports meet the Safety Extra Low Voltage (SELV) circuits for
connection to customer-owned devices and networks. Additions of
customer-owned or third party accessories that are attached to the
Xerox Nuvera Printer must meet or exceed the requirements
Xerox Nuvera Getting Started Guide