Epson Stylus Color 200 User Manual page 68

Auto line feed. Specifies that a carriage return character
encountered in the print file be accompanied by a line feed
command. By default, auto line feed is off. If text lines print
on top of one another, turn on auto line feed.
Loading position. Determines the top margin by defining
how close to the paper edge the first line can print. The
loading position can be 3 mm or 8.5 mm (default).
Normally you should use your software to adjust your top
margin.
Font and Pitch. Select the built-in printer font and
character pitch used as the default setting. The factory
default pitch is 10 cpi (characters per inch); the default font
is Courier. Generally you use your software to select the
font and pitch.
Thick paper. Select Envelope (default) if you print on thick
paper or envelopes.
Monochrome print speed. Sets a faster print speed when
the monochrome print head unit is installed. The speed can
be 167 cps (characters per second) or 125 cps (default).
Economy. Turns on economy mode for printing rough
drafts. With economy mode on, the printer uses less ink by
printing fewer dots per character. (The default setting is
off.)
To turn on the Default setting mode and print instructions,
turn off the printer. Then hold down both the Load/Eject and
Cleaning buttons while you turn the printer back on, and keep
holding down the buttons until an instruction page prints.
Follow the instructions on the page to select a language; then
press Load/Eject to print a second instruction page.
Follow the instructions the printer prints to change the default
settings by pressing buttons on the control panel. To exit
Default setting mode, wait until printing stops and turn off the
printer.
Controlling the Printer
4-9