Expansion Port Information - Enterasys Vertical Horizon VH-2402S Web Management Manual

Expansion Port Information

The Expansion Port Information screen displays the port status, link state,
the communication speed and duplex mode, as well as the flow control
status. To change any of the port settings, use the Expansion Port
Configuration menu. The parameters shown in the following figure and
table are for expansion ports.
Parameter
Admin Status
Link Status
Speed Status
Duplex Status
Flow Control Status
9033821
Figure 3-39. Expansion Port Information
Description
Shows in the port is enabled or not.
Indicates if the port has a valid connection to an external device.
Shows the port speed (10M, 100M, or 1000M).
Displays the current duplex mode (half or full duplex).
Shows the flow control type in use. Flow control can eliminate
frame loss by "blocking" traffic from end stations connected
directly to the switch. Back pressure is used for half duplex and
IEEE 802.3x for full duplex. Note that flow control should not be
used if a port is connected to a hub.
Configuring and Monitoring the Switch 45