Ip Configuration - Enterasys Vertical Horizon VH-2402S Web Management Manual

IP Configuration

Use the IP Configuration screen to set the bootup option, configure the
Ethernet IP address for the agent module, or set the number or concurrent
Telnet sessions allowed. The screen shown below is described in the
following table.
Parameter
IP State
IP Address
Master IP
Backup Master IP
Subnet Mask
9033821
Figure 3-6. IP Configuration
Default Description
USER- Specifies whether IP functionality is enabled via
CONFIG manual configuration, or set by Boot Protocol
(BootP). Options include:
BootP Get IP - IP is enabled but will not function until
a BootP reply has been received. BootP requests
will be periodically broadcast by the switch in an
effort to learn its IP address. (BootP values include
the IP address, default gateway, and subnet mask.)
USER-CONFIG - IP functionality is enabled based
on the default or user specified IP Configuration.
(This is the default setting.)
10.1.0.1 IP address of the agent you are managing. The
agent module supports SNMP over UDP/IP
transport protocol. In this environment, all systems
on the Internet, such as network interconnection
devices and any PC accessing the agent module (or
running management software) are assigned an IP
address. Valid IP addresses consist of four
numbers, of 0 to 255, separated by periods.
Anything outside of this format will not be accepted
by the configuration program.
Shows the IP address of the switch in the stack
operating as Master.
Shows the IP address of the switch in the stack
operating as Backup Master.
(Not implemented in the current firmware release.)
255.255.0.0 Subnet mask of the agent you have selected. This
mask identifies the host address bits used for
routing to specific subnets.
Configuring and Monitoring the Switch 13