Setting A Default Gateway; Setting The Administrator Password; Setting Trap Destinations - Enterasys Vertical Horizon VH-2402S Web Management Manual

Setting a Default Gateway

The default gateway parameter defines the IP address of a router or other
network device to which IP packets are to be sent if destined for a subnet
outside of that in which the switch is operating. This parameter must be
set if you are attempting to manage the switch using Enterasys WebView
from a remote network or across the Internet.
1. Starting at the Main Menu of the User Interface, select Management
Setup Menu / Network Configuration / IP Configuration.
2. Select Gateway IP from the menu and enter the router IP address.
Press <APPLY>.

Setting the Administrator Password

Management access to the switch using Enterasys WebView is restricted
based on the an administrator password. Administrators have read/write
access for parameters governing the SNMP agent. You should therefore
assign a password to the default administrator (User Name: ADMIN) as
soon as possible, and store it in a safe place. (If for some reason your
password is lost, or you cannot gain access to the system's configuration
program, contact your Enterasys distributor for assistance.)
1. Starting at the Main Menu of the User Interface, select Management
Setup Menu / Console Login Configuration.
2. Move to the Password field for the User Name "ADMIN" in this menu,
and enter the password. Press <APPLY>.

Setting Trap Destinations

If you wish to record SNMP traps, or events, generated by the switch, you
must configure the destination for IP Trap Managers. A trap destination is
the IP address of the system being used to manage the device, in this
case the IP address of the computer system on which Enterasys
WebView is being run.
1. Starting at the Main Menu of the User Interface, select Management
Setup Menu / SNMP Configuration / IP Trap Managers.
2. Select an entry for an IP Trap Manager from the menu, then enter the
IP address and community name.
3. Move to the Status field, and use the Space bar to select ENABLED.
4. Press <APPLY>.
4 Using Web-Based Management VH-2402S/VH-2402S2