Pioneer VSX-LX504 Instruction Manual page 166

Setting Item Default Value Setting Details
Output Zone Main Select the zone where you want to listen to the
music.
"Main": Outputs audio only to the main room
(where this unit is located).
"Zone 2": Outputs audio only to the separate room
(ZONE 2).
"Main/Zone 2": Outputs audio to both the main
room and separate room.
"Zone 3": Outputs audio only to the separate room
(ZONE 3).
"Main/Zone 3": Outputs audio to both the main
room and separate room (ZONE 3).
"Zone 2/Zone 3": Outputs audio to both the
separate rooms (ZONE 2 and ZONE 3).
"Main/Zone 2/Zone 3": Outputs audio to the main
room and both separate rooms (ZONE 2 and
ZONE 3).
• To use this function, set "Input Selector"
Preset Volume Main: You can set the volume beforehand for playing
Last back the Sonos Connect. You can set volumes
Zone 2: for the main room (where this unit is located) and
Last separate room (ZONE 2 or ZONE 3) respectively.
Zone 3: Select a value from "Last" (Volume level before
Last entering standby mode), "-∞ dB", and "-81.5 dB" to
"+18.0 dB".
• To use this function, set "Input Selector"
Contents
beforehand.
beforehand.
Connections
≫
Multi Zone
„ Zone 2
Change the settings for Zone 2.
Setting Item Default Value
Output Level Fixed
Volume Limit Off
Power On Level Last
Bass 0 dB
Treble 0 dB
Balance 0
166
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Select whether to adjust the volume on the pre-
main amplifier in the separate room or on this
unitwhen outputting to Zone 2.
"Fixed": Adjust on the pre-main amplifier in
theseparate room
"Variable": Adjust on this unit
Set the maximum value for Zone 2 to avoid too
high volume. Select "Off" or a value between
"-32 dB" and "+17 dB".
Set the Zone 2 volume level of when this unit is
turned on. Select a value from "Last" (volume
before the unit was turned off), "-∞ dB", and
"-81.5 dB" to "+18.0 dB".
• You cannot set a higher value than that of
"Volume Limit".
Adjust the volume of the bass for Zone 2. Select a
value between "-10 dB" and "+10 dB".
Adjust the volume of the treble for Zone 2. Select a
value between "-10 dB" and "+10 dB".
Set the left-right balance for Zone 2. Select a value
between "L + 10" to "R + 10".
≫