Pioneer VSX-LX504 Instruction Manual page 15

1. DIGITAL AUDIO IN OPTICAL/COAXIAL jacks: Input TV or AV component
digital audio signals with a digital optical cable or digital coaxial cable.
2. ANTENNA AM LOOP/FM UNBAL 75 Ω terminal: The supplied antennas are
connected.
3. COMPONENT VIDEO IN jacks: Input the AV component video signals with a
component video cable. (Compatible only with 480i or 576i resolution.)
4. Wireless antenna: Used for Wi-Fi connection or when using a BLUETOOTH
enabled device. Adjust their angles according to the connection status.
5. HDMI OUT jacks: Transmit video signals and audio signals with an HDMI
cable connected to a monitor such as a TV or projector.
6. VIDEO IN jacks: Input the AV component video signals with an analog video
cable.
7. RS-232C port: Connect a home control system equipped with an RS-232C
port. For adopting a home control system, contact the specialized stores.
8. HDMI IN jacks: Transmit video signals and audio signals with a HDMI cable
connected to an AV component.
9. NETWORK port: Connect to the network with a LAN cable.
10. USB port: A USB storage device is connected so that music files stored in
it can be played. ( p97) You can also supply power (5 V/1 A) to USB
devices with a USB cable.
11. AC IN: The supplied power cord is connected.
12. SIGNAL GND terminal: The ground wire of the turntable is connected.
13. AUDIO IN jacks: Input AV component audio signal with an analog audio cable.
14. IR IN/OUT port: Connect a remote control receiver unit. (
15. 12V TRIGGER OUT A/B jack: Connect a device equipped with a 12V trigger
input jack to enable power link operation between the device and this unit.
( p85)
16. SPEAKERS terminals: Connect speakers with speaker cables. (North
American models support banana plugs. Use a plug 4 mm in diameter. Y plug
connection is not supported.)
17. PRE OUT jacks: Connect a power amplifier. (
18. SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a
subwoofer cable. Up to two powered subwoofers can be connected. The same
signal is output from each of the SUBWOOFER PRE OUT jacks.
19. ZONE 3 PRE/LINE OUT jacks: Output audio signals with an analog audio
cable connected to a pre-main amplifier or a power amplifier in a separate
room (ZONE 3).
Contents
p84)
p67)
15
Connections
≫
HEIGHT 2 PRE OUT jacks: Connect a power amplifier. (
20. ZONE 2 PRE/LINE OUT jacks: Output audio signals with an analog audio
cable connected to a pre-main amplifier or a power amplifier in a separate
room (ZONE 2).
ZONE B LINE OUT jacks: Connect to a pre-main amplifier with an analog
audio cable, and simultaneously output audio of the same source as that of
the speakers (ZONE A) connected to this unit.
Front Panel≫
Playback Setup
≫ ≫
p67)
Rear Panel≫ Remote≫
≫