Voice Command; Headset Ringer - AT&T TL7900 User Manual

Operation
Headset operation

Voice command

The voice command feature is only available when TL7900
is registered to a TL7910/TL7912 headset base. This feature
enables you to make or answer calls using certain voice
commands. You have to install the AT&T Softphone Call
Manager on your computer to use the voice command function.
The software is available in the CD-ROM which comes with the
TL7910/TL7912 package. You may also visit
www.telephones.att.com/downloads
install the software.
For detailed instructions of the voice command feature, refer to
the Installation and Operation Guide. It is available in the
CD-ROM which comes with the TL7910/TL7912 package or the
web site stated, as mentioned above.

Headset ringer

The headset charger and headset do not have external ringers.
When you receive calls, the headset earpiece rings. If you have
telephones connected to the same telephone line as the headset
base, you can rely on the ringers of those telephones to alert
you to incoming calls.
To change the volume of the earpiece ringer:
• Slide the volume switch at the top of the headset towards
VOL+ or VOL- when the headset is not in use.
To turn off the earpiece ringer:
• Slide the volume switch at the top of the headset towards
VOL- until you hear two beeps when the headset is not in use.
24
to download and