Wire Welding Set-Up, Spool Gun - Lincoln Electric Ranger 260MPX Operator's Manual

RANGER 260MPX & 330MPX
®

WIRE WELDING SET-UP, SPOOL GUN

Electrode Positive (+) shown
Work cable (part
of K2150-1)
Work clamp (part
of K2150-1)
In the spool gun mode, the weld output is controlled by the trigger
of the spool gun. The knob on the Ranger display sets voltage and
the spool gun knob sets wire feed speed. Rotating the knob on the
spool gun adjusts the work point (wire feed speed). Spool gun
modes have the option of being "synergic" (when the wire feed
speed is changed, the voltage is automatically modi ed up or
down to maintain a similar arc length).
If desired, a remote can be plugged into the 6 pin connector for
setting the voltage away from the Ranger.
The best spool gun operation is obtained with the Magnum Pro LX
GT spool gun with mechanical gas flow trigger and Magnum Pro
consumables. The Magnum SG spool gun and Magnum PRO 100
SG spool gun are not supported.
E
F
D
G
C
B
"W" CLOCKED
CONNECTOR
(VIEWED FROM FRONT OF CONNECTOR)
A
B
G
A
D
C
E
F
FIGURE A.8
Spool Gun with
mechanical gas
valve (K3569-2)
FIGURE A.9
GRAY
YELLOW
BLACK
GREEN
BLUE
BROWN
RED
A-7
INSTALLATION
K586-1 Deluxe
Gas Regulator
and hose kit
TORCH
FUNCTIONS
+ -
TORCH
MOTOR
5K
1 3 CW
TORCH
2
POT
TORCH
TRIGGER