Connecting And Setting The Generator Lock And Time Code Input/Output; Counter Setting And Display - Panasonic P2HD AG-HPX610P Operating Instructions Manual

r When two cameras are connected and use one as a reference camera
f Set whether to use the <TC IN/OUT> terminal as an output or input at the [TC IN/OUT SEL] item on the setting menu [IN/OUT SEL] screen.
f Set the [TC VIDEO SYNC] item on the setting menu [IN/OUT SEL] screen to [RECORDING], and the [GL PHASE] item on the [OTHER FUNCTIONS]
screen to [COMPOSITE] for both cameras.
f If the [TC VIDEO SYNC] item on the setting menu [IN/OUT SEL] screen is set to [RECORDING], the same time code can be added to the video which
is recorded at the same time with both cameras.
f The sub-carrier of the VBS signal from the <MON OUT> terminal cannot be externally locked.

Connecting and setting the generator lock and time code input/output

Conditions of use of the camera
Video/reference signal supplied
Recording format
SDI output (1080i)
1080i
SDI output (1080i)
SDI output (720P)
720P
SDI output (720P)
SDI output (480i)
480i

Counter setting and display

When the counter display is set by using the <COUNTER> button, the counter value is displayed on the time code display area of the viewfinder screen.
The counter value is indicated in hours:minutes:seconds. The value is not displayed during playback.
Two types of counts are available at the [REC COUNTER] item on the setting menu [DISPLAY SETUP] screen.
Item name
[TOTAL] The count is totaled and continued until it is reset by button operation.
The counter value is held even if a P2 card is inserted or the power is turned off.
[CLIP] The counter value is cleared and the counter is started from 0 (zero) each time recording is started.
This allows shooting while constantly verifying the recording time of the clip currently being recorded.
NOTE
@
t Pressing the <RESET> button while the counter value is displayed resets the counter value and restarts the counter from 0 (zero).
t The counter value range is 0:00:00 to 9:59:59 and the count is incremented in 1-second units.
Chapter 4 Adjustments and Settings for Recording — Setting the time data
Reference camera
<TC IN/OUT> terminal
<MON OUT> terminal
Generator lock
externally
Video output
SD (480i)
Video output
Video output
SD (480i)
Video output
SD (480i)
Video output
<TC IN/OUT> terminal
<GENLOCK IN> terminal
Setting of the
camera
[GL PHASE]
input
[HD SDI]
1080i
[COMPOSITE]
[HD SDI]
[COMPOSITE]
[HD SDI]
720P
[COMPOSITE]
[HD SDI]
[COMPOSITE]
Disabled
Description
– 69 –
Slave camera
Generator lock input and output phase of the
camera
Matching: l, Not matching: ×
Video output and
SDI output (HD)
SDI output (SD)
90H delay
l
90H advance
l
90H delay
l
90H advance
l
120H delay
l
120H advance
l
120H delay
l
120H advance
l
None
l
Time code
output
l
l
l
l
×
×
l
l
l