Table of Contents
Advertisement
r Soft keyboard
Message
CANNOT CHANGE!
CANNOT SET!
INVALID VALUE!
r Hard disk drive (USB host mode)
Message
CANNOT ACCESS CARD!
CANNOT ACCESS TARGET!
CANNOT FORMAT!
CANNOT RECOGNIZE HDD!
CARD IS EMPTY! CANNOT
COPY!
FORMAT P2 CARD!
LACK OF CAPACITY!
HDD DISCONNECTED!
MISMATCH COMPONENT!
TOO MANY PARTITIONS!
TOO MANY TARGETS!
UNKNOWN DEVICE
CONNECTED!
VERIFICATION FAILED!
Chapter 10 Maintenance and Inspection — Warning system
Description
An attempt is made to enter a [PERSON] (user who enters
the memo) when a text memo is not available.
The entered value is invalid.
Description
An error occurred while accessing the P2 card.
An error occurred while accessing the connection target.
The hard disk drive cannot be initialized.
The destination target cannot be properly recognized.
The P2 card to copy is empty.
A warning indicates that the copy operation cannot be
performed at the hard disk drive → P2 import because the P2
card is already recorded.
Not enough space left on the hard disk drive.
The hard disk drive is disconnected.
The copy operation cannot be performed because the P2 card
capacities and models do not match between the source and
the target.
There are too many partitions.
Multiple devices are connected.
A non-compatible DVD drive or other device is connected.
The compare check performed after copying failed.
Enter the [TEXT] (text information) first.
Change the input value.
Check the P2 card.
Check the hard disk drive status or the connection.
Change the connected hard disk drive.
Reboot the hard disk drive or connect another hard disk drive.
The copy operation is not performed because the card is
empty.
The copy operation cannot be performed because the target
P2 card is not empty. Format the card using a P2 device and
try again.
There is not enough space on the connected target, so use a
new hard disk drive or formatted hard disk drive.
Reconnect the USB connection cable. If the hard disk drive
does not operate properly, turn it off and turn it back on again.
Use the P2 cards of the same model, or import on a clip basis.
The maximum number of partitions is 23, so use a new hard
disk drive or formatted hard disk drive.
Disconnect the devices, turn off the camera, and then turn it
back on again.
Disconnect the devices, turn off the camera, and then turn it
back on again.
Copy the data again.
– 159 –
Measure
Measure
Advertisement
Table of Contents
