Alp Does Not Detect The Evm; Alp No Devices Error; Windows 7, Alp Usb2Any Driver - Texas Instruments DS90UB954-Q1EVM User Manual

www.ti.com

1.12.2 ALP does not detect the EVM

If the following window opens after starting the ALP software, double check the hardware setup.
It may also be that the USB2ANY driver is not installed. Check the device manager. There should be a
"HID-compliant device" under the "Human Interface Devices" as shown below.
The software should start with only "DS90UB96X" in the "Devices" pull down menu. If there are more
devices then the software is most likely in demo mode. When the ALP is operating in demo mode there is
a "(Demo Mode)" indication in the lower left of the application status bar as shown below.
SNLU223 – December 2016
Submit Documentation Feedback
Figure 1-20. ALP No Devices Error
Figure 1-21. Windows 7, ALP USB2ANY Driver
Copyright © 2016, Texas Instruments Incorporated
Troubleshooting ALP Software
DS90UB954-Q1EVM User's Guide
29