Setting Up Your Autoview/Avworks System - Avocent AutoView 1000R Installer/User Manual

To connect the network and turn on your AutoView:
1. Connect your network cable from the LAN port on the rear of the
AutoView appliance to your network.
2. The components in the AutoView system may be turned on in any
order. However, since the AVRIQs are powered by the servers, turn on
the servers first and then turn on all attached systems for the most
efficient startup.

Setting Up Your AutoView/AVWorks System

See the AVWorks Installer/User Guide that ships with your appliance.
The AutoView 1000R/2000R system has an analog port that allows you to
attach a monitor and a PS/2 keyboard and mouse to the back of the unit. First,
set up your servers at the analog port via OSCAR before proceeding to the
AVWorks software to finish configuring your system. Proceed to Chapter 3 in
this installer/user guide for detailed instructions on OSCAR setup and
configuration. Once your servers are named, you will want to use a digital
station to configure the AVWorks software. See the AutoView 1000R/2000R
Quick Installation Guide for an overview of the hardware and software
installation procedure.
Chapter 2: Installation
15