Avocent AutoView 1000R Installer/User Manual page 40

34
AutoView 1000R/AutoView 2000R Installer/User Guide
-or-
To add a server in the midst of an existing list, place your cursor in the
line below where you want to insert a new server and press Insert.
4. Type the first few characters of a server name or port number to scan. The
first matching server will appear in the line.
-or-
To move through the list, press the following keyboard commands in the Name,
Port or Sec column to move through the list of servers available to scan.
a. Press Alt+Down Arrow to move the cursor down through the list
of servers.
b. Press Alt+Up Arrow to move the cursor up through the list of servers.
c. Press Alt+Home to move the cursor to the first server in the list.
d. Press Alt+End to move the cursor to the last server in the list.
5. In the Sec column, type the number of seconds (from 3 to 255) of desired
time before the scan moves to the next server in the sequence.
6. Move the cursor to the next line or press the Down Arrow and repeat steps
2-5 for each of the remaining servers to be included in the scan pattern.
7. Click OK.
To remove a server from the scan list:
1. In the Scan dialog box, click the server to be removed.
2. Press Delete.
-or-
Press Shift+Delete to remove the selected server and all entries below it.
3. Click OK.
To start the scan mode:
1. Press Print Screen. The Main dialog box will appear.
2. Click Commands. The Command dialog box appears.
Figure 3.18: Command Dialog Box
3. Select Scan Enable in the Command dialog box.